Pipe Modeling and Marking with ISOtracer

FREE Course

Self-paced Course
1 module, 30 min
Dynaflow Research Group
Luuk Hennen, MSc
SPC185

START COURSE

Course Objective

“ To teach piping engineers to effectively model piping systems and provide mark-up on isometrical drawings using ISOtracer. ”

Learn from home
100% online training

Video Lectures by Experts

watch multiple times

Available 24/7

1-year unlimited access

About the course

FREE Self-paced course

1 module

0.5 hrs duration

English

Unlimited access

SPC185

Program:

Introduction to the ISOtracer interface
Tracing ISOtracer
Inserting nodes in ISOtracer
Implementing branches in ISOtracer
Adding flanges to your model in ISOtracer
Adding supports in ISOtracer
Adding comments in ISOtracer
Interface features in ISOtracer
Exporting drawings from ISOtracer
Exporting a model from ISOtracer

Questions? Contact us

sales@engineeringtrainer.com

+31 (0)85 058 0051
Monday - Friday, 9am - 6pm CEST

With ISOtracer modelling of a piping system and marking of isometrics are done in one single step. By clicking on the isometrics along the pipe routing a 3D-model is created and the isometric is marked at the same time. A lot of valuable time is saved while isometric markings are created automatically that allow for clear and easy communication with others.

This 30 minute course demonstrates the use of ISOtracer and all its features and allows you to become fully proficient in its use.