Flanges and Flat Ends according to EN 13445

By: Dynaflow Research Group
On-Demand

Flanges and Flat Ends according to EN 13445

Unlimited Team-wide Access
Advance Technical Competences
Courses by Industry Authorities

Gain access

Additional

Quotation for your Team

Available 24/7
Training by Industry Expert
100% Online Course

About the course

Learn how to assess flanges and flat ends according to the EN 13445 design code. In this on-demand course, participants will be taken through: assessment of flat ends, circular and non-circular, welded directly to the shell, assessment of flanges and blind flanges, the steps in the "Taylor and Forge" flange assessment method in Clause 11 in EN 13445, how the method in Clause 11 differs to the Equivalent Pressure Rule, the bolt tightening limits according to EN1591-1.

On-Demand
30mins Content
0.5 PDH Credits
English
SPC118M6

This is your partner

Partner

Dynaflow Research Group

Specialised Engineering firm

Who should attend this course

• Those looking to understand how to calculate if custom and standard flanges or flat ends, including external loading, conform to EN 13445.
• Those looking for a clear step-by-step run-through of the Taylor and Forge flange assessment method, which is used in Clause 11 of EN 13445.
• Those looking for an explanation and comparison of the flange assessment methods; Equivalent Pressure, Taylor and Forge, and EN 1591-1.

Prerequisites

Technical background.

Program & Details

Flanges and Flat Ends according to EN 13445

1. Intro: Flat ends & flanges
2. Clause 10: Flat Ends
3. Flange types
4. Taylor-Forge flange check
5. Pressure rating method
6. Flange analysis
7. Module 6, Exercise 1